#LANSWEEPER FORUM 64 BIT#

I did not test for snmp configuration on the lansweeper server or the access point specifically, but snmp was mostly disabled anyway.

#LANSWEEPER FORUM 64 BIT#

Step 2 installs the MSI for 64 bit Google Chrome silently, without rebooting or any GUIs. Under the 'Version' field, Ive left blank to act as a catch all for chrome versions. The ping status is green, but the device reports a scan issue and suggests to enable snmp to scan Cisco devices. Heres what the deployment package overview looks like Step 1 uninstalls Chrome using the MSI uninstaller type in your package settings.

I looked at the asset page and the last successful scan still is from August. On the server options page -> General section we enabled all three options to enable the cleanup after 90 days and make non-active assets avtive when they are rescanned. The device is still non-active though.ĭo you need a successful scan to make and keep the device active and identify it clearly?ĭoes a successful ping (and the mac address) not work to make a device active (which was not scanned previously)?

I tried to rescan the assets and the scan attempt was changed to the current date. The time would fit the 90 day delay for the cleanup automation though. To scan a network device, do the following: Make sure you meet the network device scanning requirements. In this step-by-step guide, we walk you through configuring Cisco switches and look at some FAQs. I think there were two updates in that month, don't know if it is related to the problem. Configuring a Cisco switch properly means your network can make connections efficiently. Lansweeper data based on approximately 30 million Windows devices. I read about the automatic cleanup and how you could rescan the assets to make them visible again.Īugust was the time we updated to a new lansweeper version which installed or updated the npcap driver / ethernet device by the way. Also, future Windows 11 updates are not guaranteed if you dont meet the system requirements. I'm not really sure how that switch from active to non-active happened and when it happend (I'm not working with those on a regular basis).

access points) that have been listed as non-active.

Lansweeper forum